#Graphtec fc3100 60 driver windows 7 64 Bit#

I have tried giving the Windows 7 systems static IP addresses in the same range as the printer (10.0.1.XXX) and that hasn't made any changes and I am sort of at a loss for what to do. I have tried uninstalling and reinstalling the plotter drivers with no changes.

I have tried unistalling Cutting Master and have gone as far as manually going through the registry to clean out any keys with 'Cutting Master' in them and then reinstalling without any change. The printer was added to the Windows 7 machines using the Add a Printer Wizard as a local printer through a TCP/IP port using the plotter's IP address.ДЄll the Windows 7 machines have the Windows Firewall turned off without and 3rd party firewalls and just to be on the safe side I also put exceptions for CorelDraw and Cutting Master into the Windows Firewall. I can right click the Graphtec FC8000 in Windows >В Printers and Devices and send a test page to the printer.The plotter comes to life and starts drawing so there has to be some sort of communication going on but something is blocking Cutting Master. The plotter's IP address is 10.0.1.41 and it can be pinged from any of the Windows 7 systems. The specific issue is that when we open up Cutting Master and try a test cut we recieve an error 'Cannot Open Port'

#Graphtec fc3100 60 driver windows 7 64 Bit#

I am using the latest 64 bit driver from Graphtec's website and they assure me the driver will support Windows 7. The new machines have the exact same version of CorelDraw and Cutting Master installed as the old ones. The new machines are running Windows 7 ењ†4 and for reasons beyond what I or anyone at Graphtec have been able to figure out so far aren't playing nice. They have been using this setup without too much trouble on four Windows XP SP3 machines until recently when their machines were replaced.

There is a design department where I work and they use CorelDraw X4 to create their designs and then they use Cutting Master 2.1.60 Build 1446 to either have them drawn out or cut on vinyl.

Graphtec fc3100-60 driver windows 7